FreeSkeleton Hand Ring Holder Gothic Jewelry Stand
💀 Give your rings a spooky home! This Skeleton Hand Ring Holder adds gothic charm to your jewelry display. Perfect for Halloween! 🎃💍
Free for personal use • PixelForm Free Personal • No account needed
Print Information
- Category
- Home
- Material
- PLA
- Nozzle
- 0.4 mm
- Layer Height
- 0.20 mm
- Supports
- Yes
- Infill
- 10%
- Difficulty
- Intermediate
- License
- PixelForm Free Personal
About This Model
🖨️ Recommended Print Settings Printer: Bambu Lab P2S Nozzle: 0.4 mm Filament: PLA Matte Layer Height: 0.20 mm Initial Layer Height: 0.20 mm Print Orientation: Upright, base flat on bed Supports: Enabled where needed Filament Changes: 0 📊 Actual Bambu Studio Slicing Results: • Total Filament: 78.06 g • Model Filament: 76.42 g • Support Filament: 1.64 g • Estimated Total Time: 2h 19m • Model Printing Time: 2h 12m ✨ Printing Tips: 1. Keep the round base flat on the build plate. 2. Use supports for overhanging finger details as indicated by the slicer. 3. Check support contact points before printing. 4. Remove supports carefully around the finger joints. 5. Allow the print to cool before removing it. 6. Handle thin bone details gently. 💡 White, ivory, marble, or bone-colored PLA creates a classic skeleton appearance. Settings and estimates may vary depending on printer, filament, and model scale.
Printing Tips
- Print with the settings listed above.
Looking for something specific?
Browse the full library, or tell us what you'd like to print next.
Comments
Log in or join free to leave a comment.