FreeSleepy Bat Coffee Companion Halloween Desk Decor
Meet the Sleepy Bat Coffee Companion! 🦇☕ A spooky-cute Halloween figurine, perfect for your desk, shelf, or cozy coffee corner! 🎃
Free for personal use • PixelForm Free Personal • No account needed
Print Information
- Category
- Decor
- Material
- PLA
- Nozzle
- 0.4 mm
- Layer Height
- 0.20 mm
- Supports
- Yes
- Infill
- 10%
- Difficulty
- Intermediate
- License
- PixelForm Free Personal
About This Model
Recommended Print Settings Printer: Bambu Lab P2S Nozzle Diameter: 0.4 mm Layer Height: 0.20 mm Initial Layer Height: 0.20 mm Material: PLA Colors: 3 (White, Black, Red) Print Orientation: As shown in the print profile Supports: Included in the sliced preview Prime Tower: Enabled for multicolor printing Bambu Studio Slicing Results: Estimated Print Time: 8 hours 22 minutes Total Filament: 151.91 g Model Filament: 17.75 g Support Filament: 0.37 g Purged Filament: 120.10 g Prime Tower: 13.68 g Filament Changes: 272 Printing Tips: • Use a clean build plate for good adhesion. • Ensure all three PLA colors are loaded correctly. • Check the prime tower before printing. • Remove supports carefully around the wings and base. • Allow the model to cool before removing it. Note: Printing time and filament consumption may vary depending on printer, settings, and color-flushing adjustments. Happy printing!
Printing Tips
- Print with the settings listed above.
Looking for something specific?
Browse the full library, or tell us what you'd like to print next.
Comments
Log in or join free to leave a comment.